Shadow Hills Mastering Compressor Torrents LINK
CLICK HERE ->->->-> https://urluso.com/2tmxtm
the optical section is essentially a saturation unit for tape. the objective of the optical section is to remove any saturations that are present in the tape, and also to remove any saturation that is present in the input signal. it serves as a tape simulation unit, and is in fact the tape simulator in the chain. it also acts as a bandwidth limiting unit, and you can set the limiting up to a pretty high level. the class-a compressor has a hardwire bypass that is also completely independent of the optical section. the bypass can be set to high, mid, low, or bypass.
the buss compressor section has a bypass section that is hardwired, with the ability to bypass both sections independently. there are also variable send levels for each of the sections. the high-pass section goes from -6db at 50hz to +18db, and the low-pass section goes from -12db at 35hz to +18db. you can also use the bypass to set a custom threshold in db. the bypass can be set to high, mid, low, or bypass. so you can set thresholds that are closer to the input signal, and you can have more options for the high-pass section. if you set the bypass to mid, and the high-pass section to bypass, it will effectively function as a classic tape limiter.
the input section has a input offset of 12db, and the output section has a +12db output offset. the eq section is hardwired, and you can set the variable center frequency from 50hz to 32khz. the hardwire bypass for the class-a compressor/limiter is completely independent of the input and output sections. the bypass can be set to high, mid, low, or bypass. 3d9ccd7d82
https://www.lespepitesasso.fr/group/mysite-200-group/discussion/078324ca-e657-42f9-88dc-2744278f0ba9
https://www.raoulsalzberg.com/forum/welcome-to-the-forum/diy-egpu-setup-110b5